Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE

STEERING KNUCKLE > REMOVAL

for Preparation Click here


NOTICE:
  1. When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
  2. While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT AXLE ASSEMBLY
(Click here)


2. REMOVE FRONT AXLE HUB HOLE SNAP RING


    C112582
  1. Using snap ring pliers, remove the axle hub hole snap ring.

    NOTICE:
    When removing the hole snap ring, do not damage the magnetic rotor surface.



3. REMOVE FRONT AXLE HUB SUB-ASSEMBLY
  1. Secure the front axle assembly between aluminum plates in a vise.

    NOTICE:
    Do not overtighten the vise.



    C249884E01
  1. Using SST, remove the front axle hub sub-assembly.

    SST
    09520-00031  

    NOTICE:
    Do not drop the front axle hub sub-assembly.



    G031908E06
  1. Using SST, remove the axle hub bearing inner race.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04011, 09957-04010, 09958-04011)
    09950-60010   (09951-00370)
    Text in Illustration 
    *a
    Turn
    *b
    Hold



4. REMOVE FRONT DISC BRAKE DUST COVER


    C107919
  1. Remove the front disc brake dust cover by tapping the back with a brass bar and hammer.



5. REMOVE STEERING KNUCKLE
  1. Install the removed front axle hub bearing inner race onto the outer side of the front axle hub bearing.



    C112580E03
  1. Using SST and a press, remove the front axle hub bearing.

    SST
    09223-15020  
    09387-02010  
    09950-60010   (09951-00630)
    09950-70010   (09951-07100)