FRONT AXLE HUB > REMOVAL |
| 1. PRECAUTION |
| 2. DISABLE BRAKE CONTROL |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 3. REMOVE FRONT WHEEL |
| 4. REMOVE FRONT AXLE SHAFT NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle shaft nut.
While applying the brakes, remove the front axle shaft nut.
| 5. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and separate the front speed sensor wire and front flexible hose from the front shock absorber assembly.
![]() |
Remove the bolt and separate the front speed sensor from the steering knuckle.
| 6. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
Remove the 2 bolts and separate the front disc brake caliper assembly from the steering knuckle.
| 7. REMOVE FRONT DISC |
![]() |
Remove the front disc.
| *a | Matchmark |
| 8. SEPARATE TIE ROD END SUB-ASSEMBLY |
Remove the cotter pin and nut.
![]() |
Install SST to the tie rod end.
Secure SST using a string.
Using SST, separate the tie rod end from the steering knuckle.

| *1 | Center Nut | - | - |
| *a | String | *b | Grease Application Area |
| *c | Place the wrench here. | - | - |
| 9. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY |
![]() |
Remove the clip and nut.
![]() |
Install SST to the threaded section of the lower ball joint.
Using SST, separate the front lower No. 1 suspension arm sub-assembly LH from the steering knuckle.

| *a | Apply grease | *b | Place wrench here |
| 10. SEPARATE FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.
| *a | Matchmark |
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly. If it is difficult to separate, tap the end of the front drive shaft assembly using a brass bar and a hammer.
| 11. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.
| 12. REMOVE FRONT AXLE HUB HOLE SNAP RING |
![]() |
Using snap ring pliers, remove the axle hub hole snap ring.
| 13. REMOVE FRONT AXLE HUB SUB-ASSEMBLY |
Secure the front axle assembly between aluminum plates in a vise.
![]() |
Using SST, remove the front axle hub sub-assembly.
![]() |
Using SST, remove the axle hub bearing inner race.
| *a | Turn |
| *b | Hold |
| 14. REMOVE FRONT AXLE HUB BEARING |
Install the removed axle hub bearing inner race onto the outer side of the axle hub bearing.
![]() |
Using SST and a press, remove the axle hub bearing.