Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY (for LED Headlight)

HEADLIGHT ASSEMBLY (for LED Headlight) > DISASSEMBLY

for Preparation Click here



1. REMOVE HEADLIGHT LEVELING MOTOR


    E308379E01
  1. Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration.
    Text in Illustration 
    *a
    Aiming Screw

    HINT:
    1. Turn the aiming screw until the headlight leveling motor can be moved in the direction indicated by the arrow (2) shown in the illustration.
    2. Make sure to remember the number of aiming screw rotations.

  1. Turn the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to disengage the pin.

    HINT:
    When removing the headlight leveling motor of the headlight assembly RH, turn the headlight leveling motor in the opposite direction indicated by the arrow (2) shown in the illustration.



    E308381E01
  1. Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (3) shown in the illustration to disengage the shaft.
    Text in Illustration 
    *a
    Aiming Screw

    HINT:
    Make sure to remember the number of aiming screw rotations.

  1. Pull out the headlight leveling motor in the direction indicated by the arrow (4) shown in the illustration to remove it.



2. REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING
  1. Remove the headlight leveling motor base packing.

    NOTICE:
    After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.



3. REMOVE HEADLIGHT SOCKET COVER


    E308840
  1. Turn the headlight socket cover as shown in the illustration to remove it.



4. REMOVE HEADLIGHT LENS


    E308384E01
  1. Remove the 4 screws.
    Text in Illustration 
    *a
    Screw
    *b
    "TORX" Screw

  1. Using a T20H "TORX" driver, remove the "TORX" screw.



    E308385
  1. Using a dryer, heat the backside of the headlight unit.

    NOTICE:
    If the headlight is heated unevenly, it will deform or melt.



    E308386
  1. Disengage the 8 claws and remove the headlight lens.

    NOTICE:
    1. Wear rubber gloves when handling the headlight lens.
    2. Do not touch the lens or the aluminum surfaces with bare hands.
    3. If there are fingerprints on the aluminum surfaces, wipe them off with a soft cloth.
    4. If there are fingerprints on the back of the headlight lens, replace the headlight lens.
    5. Do not allow dirt or foreign matter to get on the headlight lens.

    HINT:
    If the lens cannot be removed even after heating, using a screwdriver with its tip wrapped in tape, lift the lens. Be careful not to damage the headlight lens and housing.



5. REMOVE HEADLIGHT LENS GASKET
  1. Remove the headlight lens gasket from the housing.