HEADLIGHT ASSEMBLY (for Halogen Headlight) > REASSEMBLY |
| 1. INSTALL HEADLIGHT LENS GASKET |
Completely remove the old headlight lens gasket.
![]() |
Partially remove the release paper, and cut off a piece of it.
| *a | Release Paper |
| *b | Tape |
| *c | Headlight Lens Gasket |
| *d | 45° |
Fold the release paper over the tip of a screwdriver and fix it in place with tape.
Using scissors, cut the end of the headlight lens gasket at an angle (45°).
![]() |
Set the headlight lens gasket into the groove so that the ends of the gasket are aligned with the bottom of the housing, as shown in the illustration.
| *a | 10 mm (0.394 in.) or more |
Using the screwdriver, completely press the headlight lens gasket into the housing to install it.
After pressing the headlight lens gasket completely, check that the ends overlap for 10 mm (0.394 in.) or more.
| 2. INSTALL HEADLIGHT LENS |
![]() |
Engage the 8 claws and install the headlight lens to the housing.
![]() |
Using a T20H "TORX" driver, install the "TORX" screw.
| *a | Screw |
| *b | "TORX" Screw |
Install the 4 screws.
| 3. INSTALL HEADLIGHT LEVELING MOTOR BASE PACKING |
Install a new headlight leveling motor base packing.
| 4. INSTALL HEADLIGHT LEVELING MOTOR |
![]() |
Insert the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration.
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to engage the shaft.
| *a | Aiming Screw |
![]() |
Turn the headlight leveling motor in the direction indicated by the arrow (3) shown in the illustration and engage the pin to install the headlight leveling motor to the headlight unit.
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (4) shown in the illustration to install it.
| *a | Aiming Screw |
| 5. INSTALL NO. 2 HEADLIGHT BULB |
![]() |
Turn the No. 2 headlight bulb as shown in the illustration to install it.
| 6. INSTALL NO. 1 HEADLIGHT BULB |
![]() |
Turn the No. 1 headlight bulb as shown in the illustration to install it.