REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY |
| 1. REMOVE REAR TURN SIGNAL LIGHT BULB |
![]() |
Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.
Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
| 2. REMOVE TAIL LIGHT BULB |
![]() |
Turn the rear combination light socket and wire sub-assembly with the tail light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.
Remove the tail light bulb from the rear combination light socket and wire sub-assembly.
| 3. REMOVE BACK-UP LIGHT BULB (w/o Rear Fog Light) |
![]() |
Disengage the 2 guides and disconnect the rear combination light socket and wire sub-assembly.
Turn the rear combination light socket and wire sub-assembly with the back-up light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.
Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.
| 4. REMOVE NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light) |
![]() |
Disengage the 2 guides and disconnect the rear combination light socket and wire sub-assembly.
Turn the rear combination light socket and wire sub-assembly with the No. 1 rear fog light bulb in the direction indicated by the arrow shown in the illustration, and disconnect them as a unit.
Remove the No. 1 rear fog light bulb from the rear combination light socket and wire sub-assembly.
| 5. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Disengage the clamp and remove the rear combination light socket and wire sub-assembly.
| 6. REMOVE REAR COMBINATION LIGHT LED |
![]() |
Remove the screw and rear combination light LED.