Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR TURN SIGNAL LIGHT BULB


    E308372
  1. Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

  1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.



2. REMOVE BACK-UP LIGHT BULB (w/o Rear Fog Light)


    E308374
  1. Disengage the guide and disconnect the rear combination light socket and wire sub-assembly.

  1. Turn the rear combination light socket and wire subassembly with the back-up light bulb as shown in the illustration to disconnect them as a unit.

  1. Remove the back-up light bulb from the rear combination light socket and wire sub-assembly.



3. REMOVE NO. 1 REAR FOG LIGHT BULB (w/ Rear Fog Light)


    E308374
  1. Disengage the guide and disconnect the rear combination light socket and wire sub-assembly.

  1. Turn the rear combination light socket and wire sub-assembly with the No. 1 rear fog light bulb as shown in the illustration to disconnect them as a unit.

  1. Remove the No. 1 rear fog light bulb from the rear combination light socket and wire sub-assembly.



4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY


    E308376
  1. Disengage the 2 guides.

  1. Turn the rear combination light socket and wire subassembly as shown in the illustration to disconnect them as a unit.

  1. Disconnect the connector to remove the rear combination light socket and wire sub-assembly.