Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

AIR CONDITIONING SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Air conditioning system data and the Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the intelligent tester to check for malfunctions and perform troubleshooting.


CHECK DLC3
  1. Check the DLC3 (Click here).


LIST OF OPERATION METHODS


  1. By operating each of the air conditioning control switches as shown in the diagram below, it is possible to enter diagnostic check mode.


    E236715E07


INDICATOR CHECK
  1. Turn the power switch off.

  2. Turn the power switch on (ACC) and wait at least 5 seconds.



  3. Turn the power switch on (IG) while pressing the air conditioning control assembly "AUTO" switch and "Recirculation/Fresh" switch simultaneously. Hold both switches until the indicator check screen appears.


    E245081E01


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD



  4. The indicator check is automatically performed when panel diagnosis is activated. Check that the indicators light up and go off 4 times at 1 second intervals continuously.


    E245082E01


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *a
    Indicator Blinking Pattern
    *b
    ON
    *c
    OFF
    *d
    1 sec.

    HINT:
    1. The sensor check automatically starts when the indicator check is completed.
    2. Press the "OFF" switch to cancel check mode.


SENSOR CHECK (DTC CHECK)
  1. Start the hybrid system and warm it up.

  2. Perform the indicator check.

    HINT:
    After the indicator check is completed, the system enters DTC check mode automatically.



  3. Read the DTC displayed on the accessory meter display.


    E245083E01


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *a
    Diagnostic Trouble Code (DTC)
    -
    -

    NOTICE:
    In sensor check mode, which is automatically entered after indicator check mode, troubleshooting may be partially performed. Be sure to perform the sensor check again.

    HINT:
    Refer to Diagnostic Trouble Code Chart for details of the codes (Click here).
    1. When there are no problems, DTC 00 is output.
    2. As an example, the illustration shows that DTC 12 is output.



  4. If the DTCs are difficult to read because they change automatically, turn the "TEMP" switch clockwise to display the DTCs one at a time so that they can be read easily. The DTCs change step by step each time the "TEMP" switch is turned clockwise.


    E245084E01


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD

    HINT:
    Press the "OFF" switch to finish panel diagnosis.



  5. Clear DTCs



    1. During the sensor check, press the "FRONT DEF" switch and "REAR DEF" switch simultaneously.


      E245085E01


      Text in Illustration 
      *A
      for LHD
      *B
      for RHD