Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE (for Front Side)

WASHER NOZZLE (for Front Side) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for LHD)


  1. Operate the front washer nozzle and check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E237638E01


    Text in Illustration 
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    *d
    Measurement

    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    28.2 mm (1.11 in.)
    B
    257.4 mm (10.1 in.)
    C
    166.8 mm (6.57 in.)
    D
    90.4 mm (3.56 in.)

    HINT:
    If the result is not as specified, replace the washer nozzle sub-assembly.



2. INSPECT WASHER NOZZLE SUB-ASSEMBLY (for RHD)


  1. Operate the front washer nozzle and check the position that the washer fluid hits the windshield.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.



    E237637E01


    Text in Illustration 
    *a
    Upper Limit
    *b
    Standard
    *c
    Lower Limit
    *d
    Measurement

    Standard Clearance 
    Area
    Measurement
    Area
    Measurement
    A
    20.6 mm (0.811 in.)
    B
    273.5 mm (10.8 in.)
    C
    184.6 mm (7.27 in.)
    D
    83.4 mm (3.28 in.)

    HINT:
    If the result is not as specified, replace the washer nozzle sub-assembly.