REAR DOOR LOCK > INSPECTION |
| 1. INSPECT REAR DOOR LOCK ASSEMBLY LH |
![]() |
Check the operation of the door lock motor.
Apply auxiliary battery voltage and check the operation of the rear door lock motor.
| Measurement Condition | Specified Condition |
| Auxiliary battery positive (+) → Terminal 4 (L) Auxiliary battery negative (-) → Terminal 1 (UL) | Locks |
| Auxiliary battery positive (+) → Terminal 1 (UL) Auxiliary battery negative (-) → Terminal 4 (L) | Unlocks |
| *a | Component without harness connected (Rear Door Lock Assembly LH) |
| *b | Unlock |
| *c | Lock |
![]() |
Check the resistance of the unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (LSSR) - 9 (E) | Locked | 10 kΩ or higher |
| Unlocked | Below 1 Ω |
| *a | Component without harness connected (Rear Door Lock Assembly LH) |
| *b | Unlock |
| *c | Lock |
| 2. INSPECT REAR DOOR LOCK ASSEMBLY RH |
![]() |
Check the operation of the rear door lock motor.
Apply auxiliary battery voltage and check the operation of the rear door lock motor.
| Measurement Condition | Specified Condition |
| Auxiliary battery positive (+) → Terminal 4 (L) Auxiliary battery negative (-) → Terminal 1 (UL) | Locks |
| Auxiliary battery positive (+) → Terminal 1 (UL) Auxiliary battery negative (-) → Terminal 4 (L) | Unlocks |
| *a | Component without harness connected (Rear Door Lock Assembly RH) |
| *b | Unlock |
| *c | Lock |
![]() |
Check the operation of the unlock detection switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 (LSSR) - 9 (E) | Locked | 10 kΩ or higher |
| 6 (LSSR) - 9 (E) | Unlocked | Below 1 Ω |
| *a | Component without harness connected (Rear Door Lock Assembly RH) |
| *b | Unlock |
| *c | Lock |