OUTER REAR VIEW MIRROR > REMOVAL |
| 1. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) |
![]() |
Disengage the 10 claws and 4 guides.
Disconnect the connector and remove the power window regulator master switch assembly with front door armrest base panel.
| 2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) |
![]() |
Disengage the 10 claws and 4 guides.
Disconnect the connector and remove the power window regulator switch assembly with front door armrest base panel.
| 3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
![]() |
Remove the 3 screws.
![]() |
Disengage the 8 clips and remove the front door trim board sub-assembly as shown in the illustration.
![]() |
Disconnect the front door lock remote control cable assembly and front door inside locking cable from the front door trim board sub-assembly.
| *1 | Front Door Inside Locking Cable Assembly |
| *2 | Front Door Lock Remote Control Cable Assembly |
| 4. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY WITH COVER |
![]() |
Disconnect the connector.
Remove the 3 screws.
Disengage the claw and remove the outer rear view mirror assembly with cover.
| 5. REMOVE OUTER MIRROR |
![]() |
Push the upper part of the outer mirror surface and tilt it.
| *1 | Protective Tape |
| *2 | Moulding Remover |
Apply protective tape to the lower of the outer rear view mirror assembly with cover.
Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror assembly with cover, and separate the outer mirror.
Push the lower part of the mirror surface and tilt it.
![]() |
Apply protective tape to the upper of the outer rear view mirror assembly with cover.
| *1 | Protective Tape |
| *2 | Moulding Remover |
Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror assembly with cover, and remove the outer mirror.
| 6. REMOVE OUTER MIRROR COVER |
![]() |
Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.
![]() |
Remove the screw.
Disengage the guide and remove the visor inner cover.
![]() |
Disengage the claw at bottom of the outer rear view mirror assembly.
![]() |
Disengage the 4 claws and remove the outer mirror cover.