Home › Vehicle Interior › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
The ECU stores trouble codes when malfunctions occur.
The diagnostic system allows for reading of the trouble codes from the DLC3.
Use the intelligent tester to help diagnose and repair the problem.

CHECK DLC3
  1. Check the DLC3 (Click here).


INSPECT AUXILIARY BATTERY VOLTAGE
  1. Measure the vehicle auxiliary battery voltage with the power switch off.

    Standard Voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge or replace the auxiliary battery.


SELF-DIAGNOSTIC MODE (USING INTELLIGENT TESTER)
  1. Connect the intelligent tester to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Entry&Start / Utility / Wireless Door Lock Diagnosis Mode.

  5. Proceed to the next step in accordance with the prompts on the intelligent tester screen.



  6. B220865E12
  7. Check that the system has switched to self-diagnostic mode by checking the wireless door lock buzzer output pattern.



  8. Check the diagnostic outputs when an electrical key transmitter sub-assembly switch is held down. The diagnostic outputs can be checked by the interior light and wireless door lock buzzer patterns.


    B163380E42

    Result 
    Wireless Door Lock Buzzer Output
    Suspected Area
    A
    Normal (No malfunction)
    B
    Register wireless code
    C
    Wave interference or malfunction of a related component