AIR CONDITIONING PANEL > REMOVAL |
| 1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a moulding remover, disengage the 8 clips and claw.
Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.
| 2. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD) |
![]() |
Disengage the 3 clips and remove the No. 2 instrument panel register assembly.
| 3. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for RHD) |
![]() |
Disengage the 3 clips and remove the No. 1 instrument panel register assembly.
| 4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Using a moulding remover, disengage the 12 clips and 10 guides to remove the instrument cluster finish panel garnish.
| 5. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL GARNISH |
for LHD:
![]() |
Disengage the 3 claws, 8 clips and 3 guides, and remove the lower instrument cluster finish panel garnish as shown in the illustration.
for RHD:
![]() |
Disengage the 2 claws, 8 clips and 4 guides, and remove the lower instrument cluster finish panel garnish as shown in the illustration.
| 6. REMOVE AIR CONDITIONING CONTROL ASSEMBLY |
![]() |
Disengage the 4 clips.
Disconnect the connector to remove the air conditioning control assembly.