Home › Power Source / Network › 1NZ-FXE BATTERY / CHARGING › AUXILIARY BATTERY

AUXILIARY BATTERY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE AUXILIARY BATTERY


    A267414
  1. Remove the 2 nuts.

  1. Remove the battery clamp.



    A267415
  1. Open the battery terminal cap.

  1. Loosen the nut, and disconnect the positive (+) battery terminal.

  1. Disconnect the battery ventilation hose.

  1. Remove the battery.

  1. Remove the battery insulator.