Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH

STOP LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT STOP LIGHT SWITCH ASSEMBLY


    E248380E21
  1. Disconnect the A65 connector from the stop light switch assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A65-1 (B) - A65-3 (GND)
    Power switch off
    11 to 14 V
    A65-5 (B) - A65-3 (GND)*1
    Power switch on (IG)
    11 to 14 V

    1. *1: w/ Cruise Control System
    Text in Illustration 
    *A
    w/ Cruise Control System
    *a
    Front view of wire harness connector
    (to Stop Light Switch Assembly)
    If the result is not as specified, replace the stop light switch assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A65-3 (GND) - Body ground
    Always
    Below 1 Ω



    E248381E07
  1. Reconnect the A65 connector to the stop light switch assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A65-2 (OUT) - A65-3 (GND)
    Power switch off, brake pedal not depressed
    Below 1 V
    A65-2 (OUT) - A65-3 (GND)
    Power switch off, brake pedal depressed
    11 to 14 V
    A65-4 (L) - A65-3 (GND)*1
    Power switch on (IG), brake pedal not depressed
    11 to 14 V
    A65-4 (L) - A65-3 (GND)*1
    Power switch on (IG), brake pedal depressed
    Below 1 V

    1. *1: w/ Cruise Control System
    Text in Illustration 
    *A
    w/ Cruise Control System
    *a
    Component with harness connected
    (Stop Light Switch Assembly)
    If the result is not as specified, replace the stop light switch assembly.