Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM

WIPER AND WASHER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK HEADLIGHT CLEANER CONTROL RELAY

E238428E01

  1. Disconnect the A44 headlight cleaner control relay connector.

  2. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    A44-1 (HDLO) - A44-4 (E)
    L - W-B
    Low beam headlight signal
    Light control switch in head position
    Below 1 V
    Light control switch off
    11 to 14 V
    A44-2 (H) - A44-4 (E)
    G - W-B
    Headlight cleaner switch operation signal
    Power switch on (IG) and headlight cleaner switch off
    11 to 14 V
    Power switch on (IG), light control switch in head position and headlight cleaner switch on
    Below 1 V
    A44-3 (IG) - A44-4 (E)
    V - W-B
    Power switch on (IG) signal (Power source circuit)
    Power switch off
    Below 1 V
    Power switch on (IG)
    11 to 14 V
    A44-4 (E) - Body ground
    W-B - Body ground
    Body ground
    Always
    Below 1 Ω
    A44-5 (FRWA) - A44-4 (E)
    Y - W-B
    Front washer switch signal
    Power switch on (IG) and front washer switch off
    11 to 14 V
    Power switch on (IG) and front washer switch on
    Below 1 V
    A44-6 (PB) - A44-4 (E)
    R - W-B
    Headlight cleaner motor drive output
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness.


CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

E248692E01

  1. Measure the voltage and check for pulses according to the value(s) in the table below.

    Terminal No. (Symbol)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    3C-18 (HRLY) - Body ground
    V - Body ground
    Headlight relay drive output
    Light control switch in head position
    Below 1 V
    Light control switch not in head position
    11 to 14 V
    If the result is not as specified, the main body ECU (multiplex network body ECU) or instrument panel junction block assembly may have a malfunction.