Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (w/ Removable Headrest)

FRONT SEAT ASSEMBLY (w/ Removable Headrest) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
  1. Be sure to read precaution thoroughly before servicing (Click here).
  2. If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE FRONT SEAT HEADREST ASSEMBLY


5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER
  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B301346
  1. Disengage the 3 claws to remove the rear outer seat track bracket cover.



6. REMOVE FRONT SEAT ASSEMBLY


    B301347
  1. Using a E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B299155
  1. Using a E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.

  1. Disconnect each connector and clamp under the seat.

  1. Lift up the seat track adjusting handle and move the seat to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.