FRONT SEAT ASSEMBLY (w/ Removable Headrest) > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE FRONT FLOOR COVER RH (for Separate Type Seatback) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. REMOVE FRONT SEAT HEADREST ASSEMBLY |
| 5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER |
Lift up the seat track adjusting handle and move the seat to the foremost position.
![]() |
Disengage the 3 claws to remove the rear outer seat track bracket cover.
| 6. REMOVE FRONT SEAT ASSEMBLY |
![]() |
Using a E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Using a E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.
Disconnect each connector and clamp under the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.
Remove the front seat assembly.