REAR AXLE HUB > REMOVAL |
| 1. PRECAUTION |
| 2. DISABLE BRAKE CONTROL |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 3. REMOVE REAR WHEEL |
| 4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
![]() |
Release the parking brake and remove the rear brake drum.
![]() | Contract |
Remove the shoe adjusting hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 5. DISCONNECT SKID CONTROL SENSOR WIRE |
![]() |
Disengage the 3 claws and remove the connector cover.
![]() |
Disconnect the skid control sensor wire connector from the rear axle hub and bearing assembly.
| 6. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.