CAN COMMUNICATION SYSTEM > Open in One Side of CAN Branch Line |
| Symptom | Trouble Area |
| 2 or more ECUs and/or sensors do not appear on the GTS CAN Bus Check screen. | One side of CAN branch line is open, or output signals are incomplete.
|
| 1.CHECK FOR OPEN IN ONE SIDE OF V BUS BRANCH LINE |
Based on the vehicle equipment and specifications, confirm the systems that use CAN communication (Click here).
Using the GTS, select and perform the CAN bus check (Click here).
Observe the screen for approximately 2 minutes to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.
Check the applicable communication stop mode for the ECU or sensor that is not displayed on the screen.
| NEXT | ||
| ||