Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR

AMBIENT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY)


    E214922E28
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-1 (+) - A26-2 (-)
    10°C (50°F)
    3.00 to 3.73 kΩ
    A26-1 (+) - A26-2 (-)
    15°C (59°F)
    2.45 to 2.88 kΩ
    A26-1 (+) - A26-2 (-)
    20°C (68°F)
    1.95 to 2.30 kΩ
    A26-1 (+) - A26-2 (-)
    25°C (77°F)
    1.60 to 1.80 kΩ
    A26-1 (+) - A26-2 (-)
    30°C (86°F)
    1.28 to 1.47 kΩ
    A26-1 (+) - A26-2 (-)
    35°C (95°F)
    1.00 to 1.22 kΩ
    A26-1 (+) - A26-2 (-)
    40°C (104°F)
    0.80 to 1.00 kΩ
    A26-1 (+) - A26-2 (-)
    45°C (113°F)
    0.65 to 0.85 kΩ
    A26-1 (+) - A26-2 (-)
    50°C (122°F)
    0.50 to 0.70 kΩ
    A26-1 (+) - A26-2 (-)
    55°C (131°F)
    0.44 to 0.60 kΩ
    A26-1 (+) - A26-2 (-)
    60°C (140°F)
    0.36 to 0.50 kΩ

    If the resistance is not as specified, replace the ambient temperature sensor (thermistor assembly).
    Text in Illustration 
    *a
    Component without harness connected
    (Ambient Temperature Sensor (Thermistor Assembly))
    *b
    Sensing Portion
    *c
    Resistance (kΩ)
    *d
    Allowable Range
    *e
    Temperature (°C (°F))

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).