Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (for LHD)


    E223779E29
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Light Control Switch 
    Tester Connection
    Condition
    Specified Condition
    18 (T) - 12 (EL)
    Light control switch off
    10 kΩ or higher
    20 (H) - 12 (EL)
    10 kΩ or higher
    18 (T) - 12 (EL)
    Light control switch in tail position
    Below 1 Ω
    18 (T) - 12 (EL)
    Light control switch in head position
    Below 1 Ω
    20 (H) - 12 (EL)
    Below 1 Ω
    Dimmer Switch 
    Tester Connection
    Condition
    Specified Condition
    11 (HU) - 12 (EL)
    Dimmer switch in high position
    Below 1 Ω
    11 (HU) - 12 (EL)
    Dimmer switch in high flasher position
    Below 1 Ω
    17 (HF) - 12 (EL)
    Below 1 Ω
    Turn Signal Switch 
    Tester Connection
    Condition
    Specified Condition
    13 (TR) - 12 (EL)
    Neutral
    10 kΩ or higher
    15 (TL) - 12 (EL)
    10 kΩ or higher
    13 (TR) - 12 (EL)
    Right turn
    Below 1 Ω
    15 (TL) - 12 (EL)
    Left turn
    Below 1 Ω
    Front Fog Light Switch 
    Tester Connection
    Condition
    Specified Condition
    4 (BFG) - 3 (LFG)
    Front fog light switch off
    10 kΩ or higher
    4 (BFG) - 3 (LFG)
    Front fog light switch on
    Below 1 Ω
    Rear Fog Light Switch*1 
    Tester Connection
    Condition
    Specified Condition
    2 (B) - 3 (LFG)
    Front fog light switch off
    10 kΩ or higher
    2 (B) - 3 (LFG)
    Front fog light switch on
    Below 1 Ω

    1. *1: w/ Rear Fog Light
    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Dimmer Switch Assembly)
    If the result is not as specified, replace the headlight dimmer switch assembly.



2. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY (for RHD)


    E223779E30
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Light Control Switch 
    Tester Connection
    Condition
    Specified Condition
    13 (T) - 19 (EL)
    Light control switch off
    10 kΩ or higher
    11 (H) - 19 (EL)
    Light control switch off
    10 kΩ or higher
    13 (T) - 19 (EL)
    Light control switch in tail position
    Below 1 Ω
    13 (T) - 19 (EL)
    Light control switch in head position
    Below 1 Ω
    11 (H) - 19 (EL)
    Light control switch in head position
    Below 1 Ω
    Dimmer Switch 
    Tester Connection
    Condition
    Specified Condition
    20 (HU) - 19 (EL)
    Dimmer switch in low position
    10 kΩ or higher
    20 (HU) - 19 (EL)
    Dimmer switch in high position
    Below 1 Ω
    14 (HF) - 19 (EL)
    Dimmer switch in high flash position
    Below 1 Ω
    Turn Signal Switch 
    Tester Connection
    Condition
    Specified Condition
    16 (TR) - 19 (EL)
    Neutral
    10 kΩ or higher
    18 (TL) - 19 (EL)
    10 kΩ or higher
    16 (TR) - 19 (EL)
    Right turn
    Below 1 Ω
    18 (TL) - 19 (EL)
    Left turn
    Below 1 Ω
    Front Fog Light Switch 
    Tester Connection
    Condition
    Specified Condition
    7 (BFG) - 8 (LFG)
    Font fog light switch off
    10 kΩ or higher
    7 (BFG) - 8 (LFG)
    Font fog light switch on
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Dimmer Switch Assembly)
    If the result is not as specified, replace the headlight dimmer switch assembly.