Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT EVAPORATOR TEMPERATURE SENSOR

FRONT EVAPORATOR TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


  1. Measure the resistance according to the value(s) in the table below.


    E247621E02

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    b1-1 - b1-2
    -10°C (14°F)
    7.30 to 9.10 kΩ
    b1-1 - b1-2
    -5°C (23°F)
    5.65 to 6.95 kΩ
    b1-1 - b1-2
    0°C (32°F)
    4.40 to 5.35 kΩ
    b1-1 - b1-2
    5°C (41°F)
    3.40 to 4.15 kΩ
    b1-1 - b1-2
    10°C (50°F)
    2.70 to 3.25 kΩ
    b1-1 - b1-2
    15°C (59°F)
    2.14 to 2.58 kΩ
    b1-1 - b1-2
    20°C (68°F)
    1.71 to 2.05 kΩ
    b1-1 - b1-2
    25°C (77°F)
    1.38 to 1.64 kΩ
    b1-1 - b1-2
    30°C (86°F)
    1.11 to 1.32 kΩ

    If the resistance is not as specified, replace the evaporator temperature sensor (No. 1 cooler thermistor).
    Text in Illustration 
    *a
    Component without harness connected
    (Evaporator Temperature Sensor (No. 1 Cooler Thermistor))
    *b
    Sensing Portion
    *c
    Resistance (kΩ)
    *d
    Allowable Range
    *e
    Temperature (°C (°F))

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring, the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).