Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › TRANSMISSION CONTROL CABLE

TRANSMISSION CONTROL CABLE > ADJUSTMENT

for Preparation Click here



1. INSPECT SHIFT LEVER POSITION
  1. While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.

  1. Turn the power switch on (READY) and check the following:

    1. When the shift lever is moved to D, the vehicle moves forward.

    2. When the shift lever is moved to R, the vehicle moves in reverse.

      NOTICE:
      The vehicle should not move when the shift position indicator is off.



2. ADJUST SHIFT LEVER POSITION
  1. Apply the parking brake and move the shift lever to N.

  1. Remove the rear console box assembly (Click here).



    C258106E01
  1. Slide the adjuster case cover in the direction shown by the arrow.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Adjuster Case Cover



    C258107E01
  1. Using a precision screwdriver, pull out the lock piece of the adjuster case.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Lock Piece

  1. Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.



    C258108E01
  1. Push in the lock piece of the adjuster case to lock it.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Lock Piece
    *3
    Cable Rod



    C258109E01
  1. Move the adjuster case cover in the direction shown by the arrow.
    Text in Illustration 
    *1
    Adjuster Case
    *2
    Lock Piece
    *3
    Adjuster Case Cover

    NOTICE:
    If the adjuster case cover is not moved far enough so that the adjuster case cover engages the lock piece, the cable will not be able to lock, and reliable shift operation will not be possible.

  1. Install the rear console box assembly (Click here).