Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › HYBRID TRANSAXLE SYSTEM

HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TRANSAXLE FLUID PRESSURE
  1. Remove the rear engine under cover LH.

  1. Lift up the vehicle.

  1. Remove the fluid pump cover plug and O-ring.



    C209291
  1. Install an oil pressure gauge with the adapter.

  1. Put the engine in inspection mode (Click here).

  1. Measure the transaxle fluid pressure.

    Reference:
    Engine Speed
    Transaxle Fluid Temperature
    Transaxle Fluid Pressure
    1000 rpm
    20 to 50°C (68 to 122°F)
    4.0 kPa (0.04 kgf/cm2, 0.6 psi) or more

    NOTICE:
    Be sure to cancel inspection mode immediately after the transaxle fluid pressure check is completed.



    C209292
  1. Install a new O-ring and fluid pump cover plug.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the rear engine under cover LH.