Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Center Pillar)

BLACK OUT TAPE (for Center Pillar) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE NO. 3 BLACK OUT TAPE
  1. Using a heat light, heat the No. 3 black out tape and vehicle body.
    Heating Temperature 
    Item
    Temperature
    No. 3 Black Out Tape and Vehicle Body
    40 to 60°C (104 to 140°F)

    NOTICE:
    Do not heat the vehicle body excessively.



    B298012
  1. Pull back on one of the ends of the No. 3 black out tape to remove it.

    HINT:
    When pulling on the stripe, pull it parallel to the body.