BATTERY BLOWER > REMOVAL |
| 1. REMOVE FRONT FLOOR COVER RH (for Separate Type Seatback) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 2. REMOVE FRONT FLOOR COVER RH (for Bench Type Seatback) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 3. REMOVE FRONT FLOOR COVER LH (for Separate Type Seatback) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover LH.
| 4. REMOVE FRONT FLOOR COVER LH (for Bench Type Seatback) |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover LH.
| 5. REMOVE FRONT CENTER FLOOR COVER (for Separate Type Seatback) |
![]() |
Using a clip remover, remove the 3 clips.
Disengage the 2 guides and remove the front center floor cover.
| 6. REMOVE FRONT CENTER FLOOR COVER (for Bench Type Seatback) |
![]() |
Using a clip remover, remove the 3 clips.
Disengage the 2 guides and remove the front center floor cover.
| 7. REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback) |
![]() |
Disengage the 2 clips.
| *a | RH Side |
| *b | LH Side |
![]() |
Disengage the hook of the rear seat cushion assembly from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 8. REMOVE REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback) |
![]() |
Using a clip remover, disengage the 2 clips.
| *a | for RH Side |
| *b | for LH Side |
![]() |
Disengage the 2 rear seat cushion lock hooks of the rear seat cushion assembly from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
![]() |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
| *a | Hook |
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 9. REMOVE BATTERY COOLING BLOWER ASSEMBLY |
![]() |
Disconnect the battery cooling blower assembly connector and disengage the clamp.
![]() |
Remove the nut, 2 bolts and battery cooling blower assembly.