CYLINDER HEAD GASKET > REMOVAL |
| 1. REMOVE TIMING CHAIN COVER |
| 2. REMOVE INTAKE MANIFOLD STAY |
![]() |
Remove the 2 bolts and intake manifold stay.
| 3. REMOVE INTAKE MANIFOLD |
![]() |
Disconnect the 4 wire harness clamps and water by-pass hose.
![]() |
Disconnect the fuel vapor feed hose and ventilation hose.
![]() |
Remove the 3 bolts, 2 nuts and intake manifold.
![]() |
Remove the ventilation hose.
![]() |
Remove the bolt and intake manifold insulator.
![]() |
Remove the No. 1 intake manifold to head gasket.
| 4. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and No. 1 exhaust manifold heat insulator.
| 5. REMOVE MANIFOLD SUPPORT BRACKET |
![]() |
Remove the 4 bolts and manifold support bracket.
| 6. REMOVE EXHAUST MANIFOLD |
![]() |
Disconnect the wire harness clamp and oxygen sensor connector.
![]() |
Remove the 3 bolts, 2 nuts and exhaust manifold.
Remove the exhaust manifold to head gasket.
| 7. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY |
![]() |
Turn the stopper plate of the No. 1 chain tensioner assembly clockwise and push in the plunger with the lock released.
| *1 | Hexagon Wrench |
| *2 | Plunger |
| *3 | Stopper Plate |
Turn the stopper plate of the No. 1 chain tensioner assembly counterclockwise and insert a hexagon wrench into the hole in the stopper plate to lock with the plunger pushed in.
![]() |
Remove the 2 bolts and No. 1 chain tensioner assembly.
| 8. REMOVE CHAIN TENSIONER SLIPPER |
![]() |
Remove the chain tensioner slipper.
| 9. REMOVE NO. 1 CHAIN VIBRATION DAMPER |
![]() |
Remove the 2 bolts and No. 1 chain vibration damper.
| 10. REMOVE CHAIN SUB-ASSEMBLY |
![]() |
Remove the chain sub-assembly.
| 11. REMOVE CAMSHAFT |
![]() |
Using several steps, uniformly loosen and remove the 19 bolts in the sequence shown in the illustration, then remove the No. 1 camshaft bearing cap and 8 No. 2 camshaft bearing caps.
Remove the camshaft and No. 2 camshaft.
| 12. REMOVE CYLINDER HEAD SUB-ASSEMBLY |
![]() |
Using several steps, uniformly loosen and remove the 10 cylinder head bolts and 10 washers with an 8 mm bi-hexagon wrench in the sequence shown in the illustration.
Remove the cylinder head sub-assembly.
| 13. REMOVE CYLINDER HEAD GASKET |
![]() |
Remove the cylinder head gasket from the cylinder block.