Home › General › SPECIFICATIONS › P510 HYBRID TRANSMISSION / TRANSAXLE

P510 HYBRID TRANSMISSION / TRANSAXLE > SERVICE DATA



Transaxle fluid pressure
Engine Speed
Transaxle Fluid Temperature
Transaxle Fluid Pressure
1000 rpm
20 to 50°C (68 to 122°F)
4.0 kPa (0.04 kgf/cm2, 0.6 psi) or more

Hybrid vehicle transaxle assembly type T oil seal
LH side
2.5 to 3.5 mm (0.0984 to 0.138 in.)
RH side
3.0 to 4.0 mm (0.118 to 0.157 in.)
Input shaft type T oil seal
1.0 to 1.8 mm (0.0394 to 0.0709 in.)
Shift lever position sensor seal
5.5 to 6.4 mm (0.217 to 0.252 in.)

Shift lever assembly
Tester Connection
Condition
Specified Condition
4 (IG) - Body ground
Power switch on (IG)
11 to 14 V
Power switch off
Below 1 V
8 (STP) - Body ground
Brake pedal depressed
11 to 14 V
Brake pedal released
Below 1 V
7 (E) - Body ground
Always
Below 1 V
Tester Connection
Shift Lever Position
Specified Condition
4 (P) - 3 (E2)
P
10 kΩ or higher
Other than P
Below 1 V
Tester Connection
Condition
Specified Condition
1 (SLS+) - 2 (SLS-)
Always
112 Ω
Shift lever position sensor
Tester Connection
Shift Lever Position
Specified Condition
7 (+B) - 1 (DB1)
D or B
Below 1 Ω
Except D or B
10 kΩ or higher
7 (+B) - 2 (N)
N
Below 1 Ω
Except N
10 kΩ or higher
7 (+B) - 3 (PR)
P or R
Below 1 Ω
Except P or R
10 kΩ or higher
7 (+B) - 4 (PNB)
P, N or B
Below 1 Ω
Except P, N or B
10 kΩ or higher
7 (+B) - 6 (DB2)
D or B
Below 1 Ω
Except D or B
10 kΩ or higher
7 (+B) - 8 (P)
P
Below 1 Ω
Except P
10 kΩ or higher
7 (+B) - 9 (R)
R
Below 1 Ω
Except R
10 kΩ or higher