Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE FRONT FLOOR COVER RH


    B301488E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301489
  1. Disengage the 3 guides and remove the front floor cover RH.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



4. REMOVE FRONT DOOR SCUFF PLATE


    B300786
  1. Disengage the 8 claws and remove the front door scuff plate LH.



5. REMOVE FRONT FLOOR COVER LH (for LH Side)


    B301490E01
  1. Using a clip remover, remove the 2 clips <A>.

  1. Disengage the 3 clips <B>.



    B301491
  1. Disengage the 3 guides and remove the front floor cover LH.



6. REMOVE REAR DOOR SCUFF PLATE


    B300785
  1. Disengage the 5 claws and guide and remove the rear door scuff plate LH.



7. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
  1. Disconnect the front door opening trim weatherstrip.



8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
  1. Disconnect the rear door opening trim weatherstrip.



9. REMOVE LAP BELT OUTER ANCHOR COVER


    B307770
  1. Disengage the 3 claws and remove the lap belt outer anchor cover.



10. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    B307771
  1. Remove the bolt and disconnect the floor anchor of the front seat outer belt assembly.



11. REMOVE CENTER PILLAR LOWER GARNISH


    B300794
  1. Disengage the 4 claws and 2 clips, and remove the center pillar lower garnish LH.



12. REMOVE CENTER PILLAR UPPER GARNISH


    B300793
  1. Remove the 2 screws and disengage the clip.

  1. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar upper garnish LH and remove the center pillar upper garnish LH.



13. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B307772
  1. Remove the bolt and the disconnect the shoulder anchor of the front seat outer belt assembly.



    B307778E01
  1. Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the pretensioner connector.



    B307779
  1. Remove the 2 bolts.

  1. Disengage the 2 hooks and remove the front seat outer belt assembly.