Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER

RADIO RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

    NOTICE:
    Do not use a moulding remover to an area other than that shown in the illustration. Using a moulding remover in an area other than that shown in the illustration may result in deformation or damage to related parts.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET


    E244891
  1. Remove the 4 screws.



    E244892
  1. Disengage the 2 guides and pull the radio receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio receiver assembly with bracket.



3. REMOVE NO. 1 RADIO BRACKET


    E237151
  1. Remove the 3 screws and No. 1 radio bracket.



4. REMOVE NO. 2 RADIO BRACKET


    E237152
  1. Remove the 3 screws and No. 2 radio bracket.



5. REMOVE RADIO RECEIVER ASSEMBLY