DTC B1242 Wireless Door Lock Tuner Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1242 |
|
|

| 1.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
![]() |
Disconnect the M15 door control receiver connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| M15-4 (+5) - M15-1 (GND) | Power switch off and electrical key transmitter sub-assembly lock/unlock switch not pressed → electrical key transmitter sub-assembly lock/unlock switch pressed | Below 1 V → 4.5 to 5.5 V |
| M15-5 (DATA) - M15-1 (GND) | All doors closed, all door lock and electrical key transmitter sub-assembly lock/unlock switch not pressed → electrical key transmitter sub-assembly lock/unlock switch pressed | 11 to 14 V pulse generation at regular intervals |
| Tester Connection | Condition | Specified Condition |
| M15-1 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector (to Door Control Receiver) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (DOOR CONTROL RECEIVER - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Disconnect the G53 and G55 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G53-7 (RSSI) - M15-2 (RSSI) | Always | Below 1 Ω |
| G53-6 (RDAS) - M15-5 (DATA) | Always | Below 1 Ω |
| G53-15 (RCO) - M15-4 (+5) | Always | Below 1 Ω |
| G55-1 (E) - Body ground | Always | Below 1 Ω |
| M15-1 (GND) - Body ground | Always | Below 1 Ω |
| G53-7 (RSSI) or M15-2 (RSSI) - Body ground | Always | 10 kΩ or higher |
| G53-6 (RDAS) or M15-5 (DATA) - Body ground | Always | 10 kΩ or higher |
| G53-15 (RCO) or M15-4 (+5) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||