DTC P2532-772 Ignition Switch Run Position Circuit High |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P2532 | 772 | Voltage is still applied to IG2 terminal although an IG2 relay off command is received from the power source CPU. |
|

| 1.CHECK DTC OUTPUT (HYBRID CONTROL) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check for DTCs.
| Result | Proceed to |
| P2532-772 only is output. | A |
| DTCs except P2532-772 are output. | B |
Turn the power switch off.
|
| ||||
| A | |
| 2.READ VALUE USING INTELLIGENT TESTER (CAN BUS CHECK) |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: System Select / Bus Check / Communication Bus Check.
| Result | Proceed to |
| All of the ECUs and sensors that are currently connected to the CAN communication system are displayed. | A |
| None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed. | B |
Turn the power switch off.
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (+B SHORT) |
![]() |
Disconnect connector A71 from the hybrid vehicle control ECU.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A71-3 (IG2) - Body ground | Power switch off | 1 V or less |
| *a | Rear view of wire harness connector (to Hybrid Vehicle Control ECU) |
Connect the hybrid vehicle control ECU connector.
|
| ||||
| OK | ||
| ||
| 4.INSPECT NO.1 INTEGRATION RELAY (IG2 RELAY) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (HYBRID VEHICLE CONTROL ECU - IG2 RELAY) |
Disconnect connector A71 from the hybrid vehicle control ECU.
Remove the No. 1 integration relay from the No. 2 engine room relay block and No. 2 junction block assembly.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A71-3 (IG2) - Body ground | Power switch off | 1 V or less |
| *a | Rear view of wire harness connector (to Hybrid Vehicle Control ECU) |
Install the No. 1 integration relay.
Connect the hybrid vehicle control ECU connector.
|
| ||||
| OK | |
| 6.CHECK FOR INTERMITTENT PROBLEMS |
|
| ||||
| OK | ||
| ||