Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Back-up Light Circuit

for Preparation Click here


DESCRIPTION

The hybrid vehicle control ECU controls the back-up lights via the BKUP LP relay.

WIRING DIAGRAM


E309200E02


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.

1.CHECK DTC OUTPUT (HYBRID CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    Hybrid control system DTCs are not output.



NG
GO TO HYBRID CONTROL SYSTEM (Click here)
OK


2.INSPECT BKUP LP RELAY


    B060778E87
  1. Remove the BKUP LP relay from the No. 2 engine room relay block and No. 2 junction block assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Voltage is applied between terminals 1 and 2
    Below 1 Ω



NG
REPLACE BKUP LP RELAY
OK


3.CHECK HARNESS AND CONNECTOR (BKUP LP RELAY - IG1 NO. 1 RELAY AND BODY GROUND)
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    Relay terminal 3 - Body ground
    Power switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay terminal 2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BKUP LP RELAY - BACK UP LIGHT LH AND BACK UP LIGHT RH)
  1. Disconnect the M5 rear combination light assembly LH connector.*

  1. Disconnect the M6 rear combination light assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay terminal 5 - M5-2 (B)*
    Always
    Below 1 Ω
    Relay terminal 5 - M6-2 (B)
    Always
    Below 1 Ω
    Relay terminal 5 - Body ground
    Always
    10 kΩ or higher

    1. *: w/o Rear Fog Light



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (BKUP LP RELAY - HYBRID VEHICLE CONTROL ECU)
  1. Disconnect the A72 hybrid vehicle control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    Relay terminal 1 - A72-2 (BL)
    Always
    Below 1 Ω
    Relay terminal 1 - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE HYBRID VEHICLE CONTROL ECU (Click here)