Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER

DOOR CONTROL TRANSMITTER > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMITTER BATTERY


    B279475
  1. Install a new transmitter battery (lithium battery: CR1632) with the positive (+) side facing upward as shown in the illustration.

    NOTICE:
    1. Be sure that the positive (+) side and the negative (-) side of the transmitter battery are matched correctly.
    2. Be careful not to bend the electrodes while installing the transmitter battery.
    3. Keep the interior of the transmitter case free of dust, water and oil.
    4. To prevent the transmitter from being damaged, be sure to touch a grounded metal surface with your bare hands to discharge any static electricity before replacing the transmitter battery.



    B279476
  1. Install the transmitter housing cover by pressing down on it as shown in the illustration.



    B279477
  1. Insert the mechanical key into the transmitter.

  1. Press one of the transmitter switches and check that the LED illuminates.

    OK:
    Transmitter LED illuminates when switch is pressed.