INTAKE MANIFOLD > INSTALLATION |
| 1. INSTALL INTAKE MANIFOLD |
Install a new No. 1 intake manifold to head gasket to the intake manifold.
Install the intake manifold insulator with the bolt.
Connect the ventilation hose.
Temporarily install the intake manifold and intake manifold stay with the 5 bolts and 2 nuts.
![]() |
Tighten the intake manifold with the 3 bolts and 2 nuts.
| *1 | Bolt |
| *2 | Nut |
Connect the fuel vapor feed hose and ventilation hose.
![]() |
Connect the 4 wire harness clamps and water by-pass hose.
| 2. INSTALL INTAKE MANIFOLD STAY |
Tighten the intake manifold stay with the 2 bolts.
| 3. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR |
Install the manifold absolute pressure sensor with the bolt.
Connect the connector.
| 4. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
Install the air cleaner case sub-assembly with the 2 bolts and grommet.
Install the air cleaner filter element sub-assembly.
| 5. INSTALL NO. 2 EGR PIPE |
![]() |
Install 2 new gaskets and the No. 2 EGR pipe with the 2 bolts and 2 nuts.
Connect the clamp and No. 2 water by-pass hose.
Connect the wire harness clamp.
| 6. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY |