Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER ASSEMBLY
  1. w/ Headlight Cleaner System:

    1. Connect the headlight cleaner hose.



    B310559
  1. Move the front bumper assembly into position and engage the 2 claws.

  1. Install the 3 clips.

  1. Pull back the side of the front bumper assembly and connect each connector.

    NOTICE:
    Do not apply excessive force when separating the front bumper.



    B310560
  1. Engage the 4 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B310561E01
  1. Install 2 new grommets as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover
    *2
    Front Bumper Cover
    *3
    Front Fender Liner

  1. Install the 2 bolts.

  1. Install the 6 screws and front bumper assembly.



2. ADD WASHER FLUID (w/ Headlight Cleaner System)
  1. Add washer fluid to the washer jar.



3. ADJUST FOG LIGHT ASSEMBLY
(Click here)