Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT BUMPER ASSEMBLY


    B392317
  1. Move the front bumper assembly into position and engage the 2 claws.

  1. Install the 3 clips.

  1. Pull back the side of the front bumper assembly and connect each connector.

    NOTICE:
    Do not apply excessive force when separating the front bumper assembly.



    B392316
  1. Engage the 4 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B392315E01
  1. Install 2 new grommets as shown in the illustration.
    Text in Illustration 
    *a
    Engine Under Cover
    *b
    Front Bumper Cover
    *c
    Front Fender Liner

  1. Install the 3 bolts.

  1. Install the front bumper assembly with the 5 screws.



2. ADJUST FOG LIGHT ASSEMBLY
(Click here)