Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY


    B310552E01
  1. Apply protective tape, as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B310553E01
  1. Remove the 5 screws.
    Text in Illustration 
    *1
    Screw
    *2
    Bolt

  1. Remove the 3 bolts.



    B310554E01
  1. Remove the 2 grommets as shown in the illustration.
    Text in Illustration 
    *1
    Engine Under Cover
    *2
    Front Bumper Cover
    *3
    Front Fender Liner



    B310555
  1. Disengage the 4 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Pull back the side of the front bumper assembly and disconnect each connector.

    NOTICE:
    Do not apply excessive force when separating the front bumper.



    B310556
  1. Remove the 3 clips.



    B310557
  1. Disengage the 2 claws as shown in the illustration.



  1. w/ Headlight Cleaner System:



      B297130
    1. Disconnect the headlight cleaner hose and drain the washer fluid.

      HINT:
      Use a container to collect the washer fluid.

  1. Remove the front bumper assembly.