Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER

FRONT BUMPER > REMOVAL

for Preparation Click here



1. REMOVE FRONT BUMPER ASSEMBLY


    B391891E01
  1. Apply protective tape around the front bumper assembly as shown in the illustration.
    Text in Illustration 
    *a
    Protective Tape



    B391892E01
  1. Remove the 5 screws.
    Text in Illustration 
    *a
    Screw
    *b
    Bolt

  1. Remove the 3 bolts.



    B391893E01
  1. Remove the 2 grommets as shown in the illustration.
    Text in Illustration 
    *a
    Engine Under Cover
    *b
    Front Bumper Cover
    *c
    Front Fender Liner



    B391897
  1. Disengage the 4 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Pull back the side of the front bumper assembly and disconnect each connector.

    NOTICE:
    Do not apply excessive force when pulling back the front bumper assembly.



    B391898
  1. Remove the 3 clips.



    B391899
  1. Disengage the 2 claws to remove the front bumper assembly as shown in the illustration.