Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > INSTALLATION

for Preparation Click here



1. INSTALL REAR BUMPER ASSEMBLY


    B307361
  1. Engage the 2 claws as shown in the illustration.



    B307362
  1. Engage the 5 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Install the rear bumper assembly with the 6 clips.



2. INSTALL REAR BUMPER CUSHION
  1. Using a T30 "TORX" socket wrench, install the 2 rear bumper cushion.



3. INSTALL NO. 1 FLOOR UNDER COVER
  1. Install the No. 1 floor under cover with the 5 clips.