REAR BUMPER > REMOVAL |
| 1. REMOVE NO. 1 FLOOR UNDER COVER |
![]() |
Remove the 5 clips and No. 1 floor under cover.
| 2. REMOVE REAR BUMPER CUSHION |
![]() |
Using a T30 "TORX" socket wrench, remove the 2 rear bumper cushions.
| 3. REMOVE REAR BUMPER ASSEMBLY |
![]() |
Apply protective tape, as shown in the illustration.
![]() | Protective Tape |
![]() |
Remove the 6 clips.
![]() |
Disengage the 5 claws as shown in the illustration.
![]() |
Disengage the 2 claws and remove the rear bumper assembly as shown in the illustration.