Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR SPOILER

REAR SPOILER > INSTALLATION

for Preparation Click here



1. INSTALL NO. 3 REAR SPOILER PROTECTOR
  1. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from 2 new No. 3 rear spoiler protectors.

  1. Align the 2 new No. 3 rear spoiler protectors with the protrusions and install them.



2. INSTALL NO. 2 REAR SPOILER PROTECTOR
  1. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from 2 new No. 2 rear spoiler protectors.

  1. Align the 2 new No. 2 rear spoiler protectors with the protrusions and install them.



3. INSTALL NO. 1 REAR SPOILER PROTECTOR
  1. Wipe off any tape adhesive residue with cleaner.

  1. Remove the release paper from a new No. 1 rear spoiler protector.

  1. Align the new No. 1 rear spoiler protector with the protrusion and install it.



4. INSTALL REAR SPOILER
  1. Install the No. 1 rear spoiler seal:

    1. Wipe off any tape adhesive residue with cleaner.

    2. Remove the release paper from 4 new No. 1 rear spoiler seals.

    3. Align the 4 new No. 1 rear spoiler seals with the protrusions and install them.

  1. Install the rear spoiler seal:

    1. Wipe off any tape adhesive residue with cleaner.

    2. Remove the release paper from a new rear spoiler seal.

    3. Align the new rear spoiler seal with the protrusion and install it.

  1. Engage the 3 clips.

  1. Install the rear spoiler with the 4 bolts.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }

  1. Install the 2 plug holes.



5. INSTALL CENTER STOP LIGHT SET
  1. Secure the wire running through the rear spoiler assembly to the center stop light set wire harness.

  1. Pull the wire to pass the center stop light set wire harness through the rear spoiler assembly.

    NOTICE:
    Do not apply excess force when pulling the wire harness or it may break.

  1. Install the center stop light set with the 2 screws to the rear spoiler assembly.

  1. Remove the wire from the center stop light set wire harness.

  1. Connect the connector.



6. INSTALL REAR LIGHT COVER
  1. Engage the 2 claws and connect the connector to the rear right cover.

  1. Engage the 6 claws to install the rear right cover.