ROOF DRIP SIDE FINISH MOULDING > INSTALLATION |
| 1. INSTALL NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP |
Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.
Press and install the 2 roof drip side finish moulding clips.
![]() |
Install 2 new clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).
| Dimension | Measurement |
| a | 2.0 mm (0.0787 in.) |
| b | 3.4 mm (0.134 in.) |
| c | 3.0 mm (0.118 in.) |
| d | 2.0 mm (0.0787 in.) |
| e | 4.9 mm (0.193 in.) |
| f | 4.0 mm (0.157 in.) |
Install the roof drip center side finish moulding when 20 minutes or more have elapsed after pressing and installing 2 new roof drip side finish moulding clips.
| 2. INSTALL ROOF DRIP SIDE FINISH MOULDING |
Engage the 2 clips and install the roof drip side finish moulding.