EXHAUST MANIFOLD > INSTALLATION |
| 1. INSTALL HEATED OXYGEN SENSOR |
![]() |
Using SST, install the heated oxygen sensor onto the front exhaust pipe.
| *a | Fulcrum Length 30 mm (1.18 in.) |
| *b | Fulcrum Length 260 mm (10.2 in.) |
| 2. INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
Install the No. 2 exhaust manifold heat insulator with the 3 bolts.
| 3. INSTALL EXHAUST MANIFOLD |
Set a new gasket to the cylinder head sub-assembly.
Temporarily install the exhaust manifold with the 3 bolts and 2 nuts.
Temporarily install the manifold support bracket with the 3 bolts.
![]() |
Tighten the exhaust manifold with the 3 bolts and 2 nuts.
| *1 | Bolt |
| *2 | Nut |
Connect the wire harness clamp and heated oxygen sensor connector.
Remove the 3 bolts and manifold support bracket.
| 4. INSTALL NO. 1 EGR PIPE |
Install a new gasket and No. 1 EGR pipe with the bolt and nut.
| 5. INSTALL MANIFOLD SUPPORT BRACKET |
![]() |
Install the manifold support bracket with the 4 bolts.
| 6. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
Install the No. 1 exhaust manifold heat insulator with the 3 bolts.
| 7. INSTALL AIR FUEL RATIO SENSOR |
![]() |
Using SST, install the air fuel ratio sensor.
| *a | Fulcrum Length 30 mm (1.18 in.) |
| *b | Fulcrum Length 260 mm (10.2 in.) |
Connect the air fuel ratio sensor connector and 2 clamps.
| 8. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
![]() |
Using a vernier caliper, measure the free length of the compression springs.
| Minimum (front) | 41.5 mm (1.64 in.) |
| Minimum (rear) | 38.5 mm (1.52 in.) |
Fully insert 2 new gaskets to the exhaust manifold converter and front exhaust pipe assembly.
![]() |
Using a plastic hammer and wooden block, tap in each new gasket until its surface is flush with the exhaust manifold and front exhaust pipe assembly.
| *1 | Exhaust Manifold and Front Exhaust Pipe Assembly |
| *2 | Gasket |
| *3 | Wooden Block |
Connect the front exhaust pipe assembly to the 3 exhaust pipe supports.
Install the front exhaust pipe assembly with the 2 compression springs, 2 bolts and 2 nuts.
![]() |
| *1 | Exhaust Manifold |
| *2 | Front Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 8.5 mm (0.335 in.) |
Install the front exhaust pipe assembly with the 2 compression springs and 2 bolts.
![]() |
| *1 | Tail Exhaust Pipe Assembly |
| *2 | Front Exhaust Pipe Assembly |
| *3 | Gasket |
| *a | Space between flanges: 6.5 mm (0.256 in.) |
| 9. INSTALL EGR COOLER ASSEMBLY |
| 10. INSPECT FOR EXHAUST GAS LEAK |