Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B278C    Lost Communication with Power Source Control

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
B278C
An internal malfunction occurs in the certification ECU (smart key ECU assembly).
  1. Certification ECU (smart key ECU assembly)

INSPECTION PROCEDURE

NOTICE:
  1. When using the intelligent tester with the power switch off, connect the intelligent tester to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and the vehicle begins. Then select Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start (CAN). While using the intelligent tester, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the intelligent tester and the vehicle.
  2. If the certification ECU (smart key ECU assembly) is replaced, refer to Service Bulletin.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    OK:
    DTC B278C is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)
OK

USE SIMULATION METHOD TO CHECK (Click here)