Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for RHD)

BRAKE PEDAL (for RHD) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
(Click here)


3. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

HINT:
Use the same procedure for LHD and RHD (Click here).



4. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY


    C249816
  1. Disconnect the connector from the brake pedal stroke sensor assembly.



    C249815
  1. Remove the 2 bolts and brake pedal stroke sensor assembly from the brake pedal support assembly.

    NOTICE:
    1. Do not drop the brake pedal stroke sensor assembly.
    2. If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.



5. REMOVE STOP LIGHT SWITCH ASSEMBLY


    E244241
  1. Disconnect the connector.



    E244242
  1. Turn the stop light switch assembly counterclockwise and remove it.



6. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER


7. REMOVE BRAKE PEDAL RETURN SPRING


    C249827
  1. Remove the brake pedal return spring from the brake pedal support assembly.



8. REMOVE PUSH ROD PIN


    C249828
  1. Remove the clip and push rod pin.

  1. Separate the push rod clevis from the brake pedal support assembly.



9. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    C249826
  1. Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement assembly.

  1. Disengage the clamp and separate the wire harness from the brake pedal support assembly.



    C249829
  1. Disengage the wire harness clamp to separate it from the stud bolt of the brake booster with master cylinder assembly.



    C249830
  1. Remove the 4 nuts and brake pedal support assembly.