DTC B2321 Driver Side Door ECU Communication Stop |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2321 | No communication between power window regulator motor assembly (for driver door) and main body ECU (multiplex network body ECU) for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - POWER WINDOW REGULATOR MOTOR ASSEMBLY) |
Disconnect the 3B instrument panel junction block assembly connector.
Disconnect the J3*1 or H3*2 power window regulator motor (for driver door) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-12 (LIN2) - J3-9 (LIN) | Always | Below 1 Ω |
| 3B-12 (LIN2) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| 3B-12 (LIN2) - H3-9 (LIN) | Always | Below 1 Ω |
| 3B-12 (LIN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY |
Remove the instrument panel junction block assembly (Click here).

Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3B-12 (LIN2) - MB-16 (LIN2) | Always | Below 1 Ω |
| *a | Component without harness connected (Instrument Panel Junction Block Assembly) | *b | Component without harness connected (Instrument Panel Junction Block Assembly) |
Install the main body ECU (multiplex network body ECU) to the instrument panel junction block assembly.
Install the instrument panel junction block assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MOTOR - AUXILIARY BATTERY, BODY GROUND) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J3-2 (B) - Body ground | Power switch off | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
| H3-2 (B) - Body ground | Power switch off | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J3-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| H3-1 (GND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for DRIVER DOOR) |
Replace the power window regulator motor assembly (for driver door) (Click here).
| NEXT | |
| 5.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Check for DTCs.
|
| ||||
| OK | ||
| ||