BACK DOOR OPENER SWITCH > INSPECTION |
| 1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY |
Check the operation of the opener switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 2 (E) - 3 (UL) | Back door opener switch not pushed | 10 kΩ or higher |
| 2 (E) - 3 (UL) | Back door opener switch pushed | Below 1 Ω |
| *a | Component without harness connected (Back Door Opener Switch Assembly) |
Check operation of the lock switch.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 1 (L) - 2 (E) | Back door lock switch not pushed | 10 kΩ or higher |
| 1 (L) - 2 (E) | Back door lock switch pushed | Below 1 Ω |
| *a | Component without harness connected (Back Door Opener Switch Assembly) |