POWER WINDOW REGULATOR MOTOR (for Front Door) > INSTALLATION |
| 1. PRECAUTION |
| 2. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY |
![]() |
Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
| 3. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY |
Apply MP grease to the sliding parts of the front door window regulator assembly.
Install the temporary bolt to the front door window regulator assembly.
![]() |
Temporarily install the front door window regulator assembly.
| *1 | Temporary Bolt |
Tighten the temporary bolt and 5 bolts.
Connect the connector.
| 4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY |
Connect the cable to the negative (-) auxiliary battery terminal and power window regulator master switch assembly and move the front door glass sub-assembly so that the door glass bolts can be seen.
Disconnect the cable from the negative (-) auxiliary battery terminal and power window regulator master switch.
![]() |
Insert the front door glass sub-assembly into the front door panel along the front door glass run as shown in the illustration.
![]() |
Install the front door glass sub-assembly with the 2 bolts.
![]() |
Install the front door No. 2 service hole cover.
| 5. INSTALL FRONT DOOR SERVICE HOLE COVER |
Apply new butyl tape to the front door panel.
Pass the front door lock remote control cable assembly and front door inside locking cable assembly through a new front door service hole cover.
![]() |
Attach the front door service hole cover according to the reference points on the front door panel.
| *a | Reference Point |
| 6. INSTALL FRONT NO. 2 SPEAKER ASSEMBLY |
Install the front No. 2 speaker assembly with the 2 screws.
Connect the connector.
| 7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
![]() |
Connect the front door lock remote control cable assembly and front door inside locking cable assembly to the front door inside handle.
| *1 | Front Door Inside Locking Cable Assembly |
| *2 | Front Door Lock Remote Control Cable Assembly |
![]() |
Engage the 8 clips.
![]() |
Install the front door trim board sub-assembly with the 3 screws.
![]() |
Engage the claw and close the cover.
| 8. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side) |
Connect the connector.
![]() |
Engage the 4 guides and 10 claws to install power window regulator master switch assembly with front door armrest base panel.
| 9. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side) |
Connect the connector.
![]() |
Engage the 4 guides and 10 claws to install power window regulator switch assembly with front door armrest base panel.
| 10. CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 11. INSTALL FRONT FLOOR COVER RH |
Engage the 3 guides.
![]() |
Engage the clip <B> to install the front floor cover RH.
Install the 2 clips <A>.
| 12. INITIALIZE POWER WINDOW CONTROL SYSTEM |
| 13. INSPECT POWER WINDOW OPERATION |