Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 IGNITION COIL


    A267419
  1. Disconnect the 4 No. 1 ignition coil connectors.

  1. Remove the 4 bolts and 4 No. 1 ignition coils.

    NOTICE:
    When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.



2. REMOVE PLUG CAP

HINT:
  1. Only perform this procedure when replacement of the plug cap is necessary.
  2. If the plug cap has any damage, replace it with a new one.



  1. Remove the plug cap from the No. 1 ignition coil.


    A326009E01


    Text in Illustration 
    *1
    No. 1 Ignition Coil
    *2
    Plug Cap
    *a
    Section (A)
    *b
    Spring
    *c
    Plug Cap Fitting
    -
    -

    NOTICE:
    1. When removing the plug cap, make sure not to damage the plug cap fitting of the No. 1 ignition coil.
    2. When removing the plug cap, do not deform the spring of the No. 1 ignition coil or allow it to fall out.
    3. If the plug cap fitting has any damage, replace the No. 1 ignition coil with a new one.
    4. If the spring is deformed or falls out, replace the No. 1 ignition coil with a new one. (The spring cannot be reassembled.)

    HINT:
    Spread section (A) of the plug cap and pull downwards to remove the plug cap.



3. REMOVE SPARK PLUG


    A267420
  1. Using a 16 mm spark plug wrench, remove the 4 spark plugs.